If you've seen a video of a Ford Focus RS in Drift Mode, you'll know just how sideways it can get.
Drift Mode is unquestionably effective at creating big yaw angles, but I’ve been wondering for some time now - can it also be used more delicately to make the RS extra agile on track?
The question first came to my mind way back in the spring, when I took an RS to Spa-Francorchamps for a track session the day after the World Endurance Championship (WEC) round. I asked Ford’s racing drivers for advice on tackling Spa, and all recommended using the drift setting for a quick lap.
“I’d use Drift Mode all the time,” was the advice of Ford GT racer Billy Johnson. “It’s more fun and agile that way.”
Inspired as I was, the following day I never managed to test Drift Mode at Spa, firstly, because I didn’t fancy the prospect of swapping ends halfway up Eau Rouge, and secondly because I didn’t want to embarrass myself in front of the pros. I decided to leave the car in the less lively Race Mode, albeit with the electronic stability programme (ESP) off, and that proved to be highly effective.
Watch the video below to see for yourself.
But that was then. I’ve grown a few more hairs on my chest since (I count two or three), so holding the keys to our long-termer RS and faced with a chilly winter morning at Bedford Autodrome, I finally feel ready to put Johnson's advice into practice.
Bedford is a familiar setting to me, and the lack of obstacles around the track make it much easier to switch off ESP and engage Drift Mode. Yet even in its slipperiest mode, the RS doesn’t immediately feel massively more agile when sticking to racing lines.
It’s happier to wag its tail on corner exits, but go into a corner at pace, hold the steering lock tight and power hard, and you’re met with understeer – the sort you’d expect in something like an Audi S3. Go in slower and hold the wheel tight before powering hard and again, the agility isn’t immediately there, but rather too much oversteer, which you naturally correct. But then Drift Mode’s unconventional torque split means you almost always over-correct and end up looking like a bit of a twat.